72-93 Dodge D100 Truck Front K-Member (ONLY)

The Skyview Racing D100 K-Member is a bolt in suspension package for 72-93 Dodge Pickups. Some fabrication work required, but in general this is a bolt in k-member. The factory frame may need to be notched for the steering shaft to clear headers. Line the front  bottom factory holes up with the rear bottom holes on K-member and drill other holes in your frame and the K-Member and it bolts into place. Fabricate new steering shaft.

• Complete Kit Weighs 155 lbs Total
• Save 175# with our complete kit!!!
• Fits 72-93 Dodge Trucks
• 1.625″ OD 4130 Chrome Moly Steel, Tig Welded
• 67″ track width
• Includes Shock Mounts, Travel Limiter Mounts and Tie Down points
• Setup for Rack & Pinion Steering Box
• Shipped Powder coated black.
• Available with Chrome Moly A-Arms with Adjustable Heim Mounts
• K-Member weight 30lbs (less a-arms, shocks,brakes, etc.)

INSTALLATION INSTRUCTIONS

-REMOVE THE FACTORY K MEMBER BY GRINDING/CUTTING RIVIT HEADS

-CUT AND REMOVE THE FACTORY DIMPLES IN FRAME WHERE STEERING BOX AND IDLER ARMS WERE LOCATED. (WE RECOMMEND USING STEEL PLATE TO PATCH THE HOLES IN FRAME)

-DRIVERS SIDE OF FACTORY FRAME MAY NEED TO BE NOTCHED FOR STEERING SHAFT TO CLEAR HEADERS

-THE BACK 2 HOLES ON FACTORY K MEMBER WILL LINE UP WITH THE BACK 2 HOLES ON OUR BOLT IN K MEMBER. YOU WILL HAVE TO DRILL THE REST OF THE HOLES WITH A 1/2″ DRILL BIT

-USING THE 1/2-20 GRADE 8 BOLTS AND NUTS SUPPLIED BOLT K MEMBER TO FRAME RAILS (THE REAR LOWER CONTROL ARM BUCKET SHOULD BE INLINE WITH YOUR SPINDLE)

– INSTALL UPPER/LOWER CONTROL ARMS. USING THE WEHR SPACERS SUPPLIED BOLT LOWER ARMS ON WITH LIMITER TABS FACING REAR OF TRUCK. (A GOOD STARTING POINT WILL BE TO SET YOUR HEIMS 5 TURNS OUT FROM ALL THE WAY IN)

-BOLT ON BILLET STEERING ARMS TO 1ST GEN CAMARO SPINDLES

-INSTALL BRAKE KIT USING 3/4-20 SPINDLE NUTS. INSTALL SHOCKS/SPRINGS (WE USUALLY SET SPRING COLLARS FOR A 6″ RIDE HEIGHT FROM THE ROCKER TO GROUND)

-24″ TRAVEL LIMITERS WILL BOLT TO THE 3/8 REAR FACING HOLE IN UPPER SHOCK MOUNTS. CABLE GOES THROUGH TAB ON LOWER ARM WITH THE CLAMPS SUPPLIED

-USING THE BILLET RACK MOUNT BOLT YOUR RACK TO K MEMBER AND INSTALL THE TIE ROD AND BUMP STEER KIT TO STEERING ARM

REFER TO PICTURES ON WEBSITE OF HOW COMPLETED ASSEMBLY SHOULD LOOK

Ships finished with k-member Powder Coated Black, Control Arms come Silver Vein Coated.
Mounting Hardware NOT included.

Ships Truck Freight, Billed Separately after Checkout.