Diagonal 4-Link Solid Axle Rear Cradle and Part for 2010-2015 5th Gen Camaro SVRC-130010

SVRC Fabricated 5th Gen Camaro (2010-2015) Diagonal 4-Link Solid Axle Rear Cradle allows you to have a fully bolt in 4-Link Rear Suspension with tons of adjustability.

• Diag. 4-Link Solid Axle rear cradle (only)
• OEM Fuel tank has to be removed and cut out brace above where tank was
• Fully bolt in Diagonal 4-Link with lots of adjustability for different intersect points
• Requires 3″ OD Steel driveshaft to keep clearance to maximum on rear trans tunnel
• Uses a 6” Travel Shock at 6.5” ride height
• We do recommend connecting the Roll Cage into the Shock Bar and the Upper Torque Boxes for Strength
• To be used with 10” wheel 3” bs. Puts inside of 275 tire at 49.5″ and the outside at 74″, factory is 53″ ID and 74.5″ OD
• Uses 3/16″ Brackets with Doublers for Maximum Stiffness
• Cradle is Designed with Shock Mount Tabs and Anti-Roll Bar Tabs installed
• Optional Fabricated SVRC 9″ Rear End available from us and all components needed to bolt in
• Mounting Hardware NOT included

INSTALLATION INTRUCTIONS

-REMOVE FACTORY IRS AND FUEL TANK
-CUT THE FLOOR BRACE OUT THAT IS IN FRONT OF SPARE TIRE WELL
-CUT THE 2 STABS OFF FACTORY FRAME WHERE IRC CRADLE BOLTED
-POSITON REAR CRADLE UNDER CAR WHERE YOU CAN MARK AROUND THE 2 UPWARD FACING TUBES ON CROSSMEMBER AND HOLE SAW 1-3/4 HOLES THROUGH FLOOR FOR BARS TO PROTRUDE THROUGH FLOOR (WE RECOMMEND TIEING THESE TUBES INTO YOUR CHASSIS FOR ADDED STRENGTH WITH 4 BOLT FLANGES)
-THE CRADLE WILL BOLT INTO FACTORY HOLES ON FLOOR AND REAR FRAME RAILS
-YOU WILL HAVE TO DRILL 3/8 HOLES IN FRAME RAIL TO ATTACH THE CROSSMEMBER FLANGES (WE RECOMMEND CUTTING A 4X4 HOLE IN BOTTOM OF FRAMERAIL TO ATTACH NUTS TO THESE BOLTS)

Ships Truck Freight, Billed Separately after Checkout.