Diagonal 4-Link Solid Axle Rear Cradle for CTS

SVRC Fabricated Diagonal 4-Link Solid Axle Rear Cradle allows you to have a fully bolt in 4-Link Rear Suspension with tons of adjustability.

• Diag. 4-Link Solid Axle rear cradle (only)
• OEM Fuel tank has to be removed and cut out brace above where tank was
• Fully bolt in Diagonal 4-Link with lots of adjustability for different intersect points
• Requires minimum of 3″ OD Steel driveshaft to keep clearance to maximum on rear trans tunnel
• Uses a 6” Travel Shock at 6.0” ride height
• We do recommend connecting the Roll Cage into the Shock Bar and the Upper Torque Boxes for Strength
• To be used with 12” wheel 3” bs. Puts inside of 275 tire at 46.5″ and the outside at 74.5″
• Uses 3/16″ Brackets with Doublers for Maximum Stiffness
• Cradle is Designed with Shock Mount Tabs and Anti-Roll Bar Tabs installed
• Optional Fabricated SVRC 9″ Rear End available from us and all components needed to bolt in
• Mounting Hardware NOT included
• Housing we use is 52.5 housing end to end

INSTALLATION INSTRUCTIONS

• REMOVE FACTORY IRS AND FUEL TANK
• CUT THE FLOOR BRACE OUT THAT IS IN FRONT OF SPARE TIRE WELL
• POSITON REAR CRADLE UNDER CAR WHERE YOU CAN MARK AROUND THE 2 UPWARD FACING TUBES ON CROSSMEMBER AND HOLE SAW 1-3/4 HOLES THROUGH FLOOR FOR BARS TO PROTRUDE THROUGH FLOOR (WE RECOMMEND TIEING THESE TUBES INTO YOUR CHASSIS FOR ADDED STRENGTH WITH 4 BOLT FLANGES)
• THE CRADLE WILL BOLT INTO FACTORY HOLES ON FLOOR AND REAR FRAME RAILS
  YOU WILL HAVE TO DRILL 3/8 HOLES IN FRAME RAIL TO ATTACH THE CROSSMEMBER FLANGES (WE RECOMMEND CUTTING A 4X4 HOLE IN BOTTOM OF FRAMERAIL TO ATTACH NUTS TO THESE BOLTS)

• Freight, Billed Separately after Checkout.